Table of Contents
Advertisement
Using
Re @ e
C@n r@M
j_
jf
_v_
Vc_2
Au×
S*_T-Ct,B_
&&oAA
¢_ ÷
You'll use these buttons when you program the
remote to operate another component.
The remote may not operate all models of
all brands.
Programming
the Remote to Operate
Other Components
"File universal renlote control can be progranlmed
to operate lllost brands
of remote controllable
VCRs, satellite receivers
and cable boxes. "File
remote is already programmed
to operate
most RCA, GE and Ph'OSCAN
TVs, VCRs, DVD players, laserdisc players and satellile receivers.
Find Out If You Need to Program
the Remote
To determine
whether the universal remote needs to be programmed,
turn a component
ON, such as a VCR, point the remote at the VCR, and
press the VCR1 button. Then press ON • OFF or channel
tip or channel
down to see it the VCR responds
to the remote commands.
If not, the
r(,niot(,
ne('ds
to be
programmt,
d.
How to Program
the Remote
There
ar(* two
ways
to prograln
tile remote controh
autonlatic
cod(*
search and direct entry. Instructions
t_)r both ways fi)llow.
To stop the automatic
code search without
programming
any components,
press and hold CLEAR
until the light on the remote turns off.
Using Automatic
Code Search
f
1.
Turn on tile component you want tile r
emote to operate (\ CR, DVD
Player, etc.)
2.
Press and hold lh(. componenl button on tile r
emole conlr ol tlmt
corresl_mds to file
comix)nen!
you vvan!/he
r
emo/c _o ()per'am
(VCR1, DVD, elc.). While you hold down the component button,
press and hold ON-OFF (when tile red light on the r emote tur ns
on, release/)c)/l_ buuons).
3.
Press PLAY (tile red light on the r emote, located below the ON-OFF
button, starts flashing).
]]le remo/(, is sear ching lhe first set of component codes (ther
e are
20 sets of codes). If tile component you want lo operate doesn't
mr n off aulomatically alh.r 5 seconds, pr
ess PLAY again (the red
light star ts tlashing again as the r emote sear ches through the next
set of codes).
Continue pressing
PLAY until tile component tur
ns off.
4.
Note: I/'the component
doesn't turn qff'qfler yoz_'_,epress(,d the
PIAY bzato_ 20 time._; the component
can't be programmed.
Press I'-dEVERSE, wait 2 seconds. Repeat this step until the
comixment/ur
ns back on.
5.
]i) finish, pr ess and hold the STOP button
until the r
ed light on the
remote turns
off.
26
Advertisement
Table of Contents
