Table of Contents
Advertisement
C@nnecti@ns
Setup
Step 3: Configuring
for a VCR
1.
If your TV is connected
to a VCR, press OK.
If it is not, highlight No and press OK (a screen will appear reminding
you
to connect your G-LINK cable to your TV and VCR.).
2.
Use the up and down arrow buttons to highlight tile brand of your VCR that
is connected
to the TV and press OK.
If: your brand
isn't listed,
highlight
Not LL_ted and press
OK.
3_
Tune your VCR to channel 02, Next, turn OFF your VCR. When you
complete
these steps, press OK to begin testing.
lmportantNote:
Whencodeleslin_,gisinpr
o£,ress, don' tloucbyoJ_rTY
,
IfCR,orar_y(?fl,Ser emolecontr
ot._:/brlb_epr
oducls.
4_
Look at the front display of your VCR. If your VCR turned on automatically
and changed
to channel 09, the test was successful.
Highlight
Yes"and
press OK.
If your VCR didn't
change
to channel
09, you can either
choose
No or It, st
this coch, ct_,dairt.
If you think your TV or remotes might have been touched
during tile test,
tune your VCR to channel
02, turn oft your VCR and highlight
7?,st tbi._
code again.
If you don't
think
the test was interrupted,
highlight
No. Tune
your VCR to
channel
02 and
turn off your VCR. Press OK (the GUIDE
Plus+
system
starts
testing
another
set of codes.)
Keep
tk)llowing
the previous
instructions
until the VCR finds
the
correct
code.
20
Chapter
I
Advertisement
Table of Contents
