RCA L42FHD37 User Manual page 44

Buttons don't work
o The side panel controls may be locked (disabled). Use the remote control to unlock the side panel controls by
selecting the Block Buttons feature in the Parental Control menu and press OK to uncheck the box.
o Unplug the TV for ten minutes and then plug it back in. Turn the TV on and try again.
TV turns off
unexpectedly
o Sleep timer may have been activated. Go to page 40 for instructions.
o Electronic protection circuit may have been activated because of a power surge. Wait 30 seconds and then
turn on again. If this happens frequently, the voltage in your house may be abnormally high or low.
o Unplug. Wait ten minutes. Plug in again.
TV turns on
unexpectedly
Wake up timer might have been activated. Go to page 40 for instructions.
Can't select certain channel
o Channel may be blocked or not approved in the Parental Control menu.
o If using a VCR, check to make sure the TV/VCR button on the VCR is in the correct mode (press the TV/VCR
button on your VCR).
o Press the TV button and then try to change channels.
Noisy stereo reception
May be a weak station. Use the Sound menu and Sound Type to choose mono.
Black box appears on the screen
Closed-captioning might be on. Check Closed Caption in the Setup menu. Go to page 39 for more instructions.
Problems with HDMI Connection
o Make sure the HDMI or DVl device is turned on and the cables are firmly connected. If problems still occur,
turn off your device. Re-connect your device. Reset the power by unplugging the power cord and plugging
it back in.
o If you are tuned to the HDMI 1, HDMI 2 or HDMI 3 INPUT and you're receiving Unusable Signa! message
onscreen, press the INFO button on the remote. If Acquiring Channelappears in the channel banner, the
HDMI or DVl device isn't responding. Contact the manufacturer of the HDMI or DVl device for further assistance.
o If you tune to the HDMI 1, HDMI 2 or HDMI 3 INPUT and you see snow, the video goes in and out, or the video
takes a long time to appear, your HDMI or DVl device is having trouble sending video information to the TV.
Re-connect your device. Reset the power by unplugging the power cord and plugging it back in. If problems
persist, try connecting the Y Pb Pr jacks if they are available or contact the manufacturer of the HDMI or DVl
device for further assistance.
o If you have black bars on each side of your picture, the device you connected might have a switch or a
menu option allowing you to change the picture quality output that will fix this. Choose either 720p or
! 080L
o 480i signals aren't supported by the HDMI2/DVl, HDMI1 or HDMI3 INPUT.
The Remote Control Doesn't Work
o Something might be between the remote and the remote light sensor on the front of the TV. Make sure
there is a clear path.
o The remote may not be aimed directly at the T_.
o The batteries in the remote may be weak, dead, or installed incorrectly. Put new batteries in the remote. (Note,
if you remove the batteries, you may have to reprogram the remote to operate other devices.)
44 <:
Other Information