RCA 20F510TD User Manual page 26

The Remote Control Doesn't Work
• Something might be between the remote and the remote sensor on the component. Make sure there is a
clear path.
• Maybe batteries in remote are weak, dead, or installed incorrectly. Put new batteries in the remote.
• You might need to reset the remote: remove batteries and press the number 1 button for at least 60
seconds. Release the 1 button, and replace the batteries.
• Make sure remote is in the correct mode (IV or DVD).
ProbJems with V-Chip/Parental Controls
The rating limits don't work
• You must activate the settings.
I don't remember my password and I want to unlock the TV
• If you forget your password you can reset it. Enter 5898 as the password and then change it to a new one.
DVD Problems
Can't advance through a movie
• You can't advance through the opening credits and warning information that appear at the beginning of
movies because the disc is programmed to prohibit that action.
The invalid icon (hand) appears on screen
• The feature or action cannot be completed at this time for one of the following reasons:
• The disc's software restricts it.
• The disc's software doesn't support that feature (e.g., angles).
• The feature is not available at the moment.
• You've requested a title or chapter number that is out of range.
The picture is distorted
• The disc might be damaged. Try another disc.
• If you're using forward or reverse buttons, it is normal for some distortion to appear while scanning.
A screen saver appears on the TV
• Your player is equipped with a screen saver that appears on the IV after your player has been idle for
several minutes. To make it disappear, press Stop or CLEARon the remote.
24 Other Information