Adding Channels To Memory; Channels Adding; Deleting; Delete Channels From Memory - RCA F20635 Owner's Manual

Placing Channels in Memory (Autoprogramming)
Ordy channels 2-13 appear in the TV's memory when you first turn it on. The channels available in your area must be
programmed into the TV's memory when you hook up your TV. Using CHANNEL up or down allows you to scan
through these channels.
You may want to add or delete a few channels if some stations have weak signals or were off the air when the TV was
programmed. Refer to the Add or Delete Channels section below.
1. Place channels in memory (Autoprogram
A. Hook up an antenna, cable or components
before you begin these steps or you will
not be able to add channels into memory.
B. Press MENU repeatedly to select the Setup
Menu and highlight Autoprogram. This
menu is white.
C. Press + to start the TV adding channels to
the channel list selected.
D. Wait until the TV has cycled through all
the channels and returns to the original
channel.
E. Press DISPLAY or DONE to remove the
menu from the screen.
Controls Alarm
13
2. Add or delete channels
A. Press MENU repeatedly to select the Setup
menu.
B. Press CHANNEL down to highlight
Channel Memory.
C. Press -I- to underline channel number.
D. Select the channel number you want to
add or delete with the number buttons.
E. Press + to add or delete a channel (you
will see Stored on the screen to add and
Erased to delete).
F. Repeat D and E for more channels.
G. Press DISPLAY or DONE to remove the
menu from the screen.
Controls Alarm Ad
Controls Alarm Ad
13
13
22