ProForm SR 30 User Manual page 6

5. Heldthe SeatFrame (6)atanangle, a ndinsert t hetab
on theSeatFrame intotheindicated slotinthe Seat
Carriage (4).Attach theSeatFrame tothe Seat
Carriage withtwoM10x 66ram Button Bolts(47)and
two M10SplitWashers ( 43).
6. Attachthe Backrest (9)totheSeatCarriage (4)with
two M6x 16mm Screws (37),anM6x 53mmScrew
(30),andanM6FlatWasher ( 38)as shown,
7. TheConsole (12)requires t hree"AA"batteries ( not
included); alkaline batteries a rerecommended. Insert
threebatteries i ntotheConsole as shown.
M ake sure
that the batteries are oriented as shown by the dia-
gram inside the Console.
8. Hold the Console (12) near the Upright (11). Insert
the console cable and the console wire into the indi-
cated hole and down through the Upright. Attach the
ground wire to the Upright with an M4 x 16mm
Screw (40).
Insert the excess wire and cable into the Upright
(11), Attach the Console (12) to the Upright with four
M4 x 16mm Screws (40). Make sure that the wires
and the cable are not pinched.
5
7
6
g\
3O
Batteries
/12
Ground Wire 40 _
Hele_w_._, \ Console Wire
11,,_/q Console Cable
,/// 40
6