Table of Contents
Advertisement
Trouble Checks
Trouble
Checks
and Adjustments
V C R .(co.t_nueal
Can't record one channel
with the VCR while
watching
a different
channel
on the TV
For connections
4B, 5B:
1. Turn on TV, VCR, satellite receiver, and cable box (if required).
2. Make sure IRD/TV switch on satellite receiver is in IV position so signal
from cable box or antenna is coming out the OUT TO "IV jack on the
satellite receiver.
3. If cable box is required,
use CHANNEL buttons on VCR to tulle VCR to
output channel of cable box (usually 02, 03, oi' 04).
4. Select channel 03 or 04 on TV (depending
on the position of the
GH3iGH4 switch on the back of the VCR).
5. Select desired
channel with CHANNEL buttons .an cable box if cable box
is required.
If cable box is not required,
select desired channel with
CHANNEL buttons on vCR.
6. Insert tape in VCR and press RECORD on VCR.
7. To watch satellite channel, select channel 00 on 17v'.
8. Then select desired channel to watch with CHANNEL buttons on
satellite receiver.
For connections
4Cr 5C:
1. Turn on TV and select channel 00 on TV with remote.
2. Turn on satellite receiver and select desired sate'.Llitechannel with
CHANNEL buttons on satellite receiver.
3. Turn on VCR and set it to line mode (see glossao" ) so you can see the
sateUite signal coming into its AUDIONIDEO
IN jacks.
4. Insert tape in VCR and press RECORD on VCR.
5. Press "FVNCR button on VCR. This lets the cable signal flow directly
out of the OUT TO FV jack of the VCR without affecting the recording.
6. If cable box is required, turn on cable box, change channel on IV to
output channel of cable box (usually
02, 03, or 04), and select desired
channel with CHANNEL buttons on cable bo_.
7. If cable box is not required,
select desired channel with CHANNEL
buttons on TV.
continued on the next page
25
Advertisement
Table of Contents
