Table of Contents
Advertisement
OPERATION
SPARK
DISCHARGE CHUTE CONTROL
LEVER
SAFETY
IGNITION
CHOKE
CON-
ENGINE OIL CAP
AUGER
*WITH DIPSTICK
CONTROL
LEVER\
DRIVE SPEED
E
_NTROL
LEVER
FILLER
CAP
CHUTE
DEFLECTOR
TRACTION
DRIVE
CONTROL
LEVER
THROTTLE
/ENGINE
CONTROL
RECOIL
POWER
(AUXILIARY)
CORD
STARTER
PLUG
HANDLE
PRIMER
NOTE: ITEMS ABOVE
ARE SHOWN IN
THEIR TYPICAL
LOCATION ON THE
ENGINE. ACTUAL
LOCATION MAY VARY
WITH THE ENGINE
ON YOUR UNIT.
AUGERS
ELECTRIC
START
BUTTON
OIL DRAIN
PLUG
FUEL SHUT*OFF VALVE
DISCHARGE
CHUTE
HANDLE
KNOB
MUFFLER
OOLBOX
SKID PLATE
FIG. 8
MEETS A.N.S.I. SAFETY REQUIREMENTS
Our snow throwers conform to the standards of the American National Standards Institute.
Toolbox - used to sto_ spar
shear bolts, Iocknuts and
wrench.
Safety ignition
key - must be inserted for the engine to
start and run. Remove when snow thrower is not in use.
Electric start button - used for starting the engine.
Recoil (auxiliary)
starter handle - used for starting the
engine.
Primer - pumps additional fuel from the carburetor to the
cylinder for use when starting a cold engine.
Throttle/engine
control - used to select either FAST or
SLOW engine speed and to STOP the engine.
9
Choke control - used for starting a cold engine.
Drive speed control lever - used to select forward or
reverse motion and speed of snow thrower.
Traction drive control lever - used to engage power-pro-
pelled forward or reverse motion of snow thrower.
Auger control lever - used to engage auger motion (throw
SNOW),
Discharge chute control lever - used to change the di-
rection the snow is thrown.
Skid plate - used to adjust height of scraper bar from the
ground.
Advertisement
Table of Contents
