Table of Contents
Advertisement
Using
the
Remote
Programming
the Remote
Control
The universal remote can be programnled
to control most brands of remote contro]lable
components,
such as VCRs. The remote is already programmed
to control most RCA, GE
and PROSCAN TVs, VCRs, DVD players, and laserdisc players.
Testing
the
Remote
Control
To determine
whether the universal remote control requires programming,
turn on a
component,
such as a VCR, point the remote control at the VCR, and press the VCR1
button. Then press ON*OFF or CH + (channel
up) or CH - (channel
down) to see if the
VCR responds
to the remote control commands.
If not, the remote control requires
programming.
Using
Automatic
Code
Search
The following instructions
can be used to program
the remote control. If you want to exit
the automatic
code search without programming
any of your components,
press and hold
CLEAR until the LED light on the remote control turns off.
1.
Turn on the component
you want to control (VCR, etc.).
2.
Press and hold the button you want to program
(VCR1, VCR2, etc.). Note that the AUX
button can only be programmed
using direct entry (see the next section for details).
While holding the component
button, press and hold ON*OFF until the LED light on
the remote control turns on, then release both buttons.
3.
Point the remote control at the component
you want it to control.
4.
Press and release PLAY, then wait five seconds
or until the LED light stops flashing.
At this point the remote control is searching
for the correct code to program. If, ali.er
five seconds,
the component
you want to control does not turn off', press PLAY again
to tell the remote control to search the next set of codes.
Continue pressing PlAY until the component
turns off or you have searched
through
all of the codes. There are 20 total sets of codes. If the component
does not turn off
after pressing PLAY 20 times, then the remote cannot control that particular
component.
If the component
you want In control
do_,s turn off:
1.
Press and release REVERSE. then "_,ait two seconds. Repeat this step until the
compunent
turns hack on.
2.
To finish, press and hold STOP until the LED light on the remote control turns off.
L.E.D.
R_VERSE
pL_y
STOP
You'll use these
buttons
when you
program
the remote
to control any
component.
The remote may not
operate all models of
all brands.
22
Chapter2
Advertisement
Table of Contents
