Table of Contents
Advertisement
Setup
and
Connections
The Advanced
Connection
TV, VCR, and
DVD
Player
With
Amplifier
_
SATELLITE
OISH%
DVD
CABLEOR
ANYALTERNAT_E
RF SIGNAL, SUCH AS
A DIG_AL
OR ANALOG
TERRESTRIALANTENNA
CABLEOR
OFF-AIRANTENNA
After you have made your
connections,
program the
TV to tune to the correct
video input channel to see
and hear audio and video
from the attached
component
(VCR, DVD
player, etc.). Program your
TV as described in the
"System Options and
Preferences"
section of
this book.
To watch the VCR in this
connection,
press INPUT on
the remote control until the
correct video input appears
(in this example, VID3).
Note that because
the digital
decoder
is in the TV, not the
VCR, you cannot record
digital channels.
To watch the DVD player in
this connection,
press INPUT
on the remote control until
the correct video input
appears (in this example, S-
VID1 ).
VCR1
Some cable systems may
require a "conversion
box." If so, consult your
cable company's box
tuning
instructions
for
details.
f
Please Read Before
Using the Digital
Audio Out Jack
This TV's optical digital output
jack fully complies with the international
standard governing
this type of jack (IEC958), and is
designed for connection
to a Dolby Digital (AC-3 or PCM) receiver or Dolby Digital (AC 3 or PCM) decoder. Older equipment,
some of which is not fully compliant
with IEC958, may not be compatible
with the Dolby Digital
bitstream.
Such a connection
using anything
other than Dolby Digital AC-3 or PCM receiver or decoder could create a high noise level, causing damage to
headphones
or speakers.
Chapter
1
15
Advertisement
Table of Contents
