Table of Contents
Advertisement
The Advanced Connection
TV, VCR, and DVD Player With Amplifier
AMPLIFIER WITH
DIGITAL
AUDIO IN
OPTICAL INPUT
CABLE OR
ANY ALTERNATE
RF SIGNAL, SUCH AS
A DIGITAL OR ANALOG
TERRESTRIAL ANTENNA
CABLE OR
OFF-AIR ANTENNA
Please Read Before Using the Digital Audio Out Jack
This TV's optical digital output jack fully complies with the international standard governing this type of jack (IEC958), and is
designed for connection to a Dolby Digital (AC-3 or PCM) receiver or Dolby Digital (AC-3 or PCM) decoder. Older equipment,
some of which is not fully compliant with IEC958, may not be compatible with the Dolby Digital bitstream. Such a connection
using anything other than Dolby Digital AC-3 or PCM receiver or decoder could create a high noise level, causing damage to
headphones or speakers.
Chapter 1
DVD
SATELLITE
DISH ANTENNA
TV
SATELLITE
IN
ACCESS CARD
DIGITAL
PHONE
AUDIO OUT
JACK
ANTENNA B
IN
ANTENNA A
IN
VCR 1
Setup and Connections
OUT
S-VIDEO
VIDEO
L
R
AUDIO
COMPONENT VIDEO INPUT
VIDEO
L
R
S-VIDEO
AUDIO
Y
P
P
R
B
R
INPUT1
AUDIO OUTPUTS
FIXED
L
L
R
INPUT2
EXT SPEAKERS
INPUT3
+
POWER
R
ANT. IN
OUT
VIDEO
L
R
RF OUT
After you have made your
connections, program the
TV to tune to the correct
video input channel to see
and hear audio and video
from the attached
component (VCR, DVD
player, etc.). Program your
TV as described in the
"System Options and
Preferences" section of
this book.
•
To watch the VCR in this
connection, press INPUT on
the remote control until the
correct video input appears
(in this example, VID3).
Note that because the digital
decoder is in the TV, not the
VCR, you cannot record
digital channels.
•
To watch the DVD player in
VARIABLE
this connection, press INPUT
L
R
on the remote control until
EXT
L
INT
the correct video input
+
R
L
appears (in this example, S-
VID1 ).
CH3
CH4
Some cable systems may
require a "conversion
box." If so, consult your
cable company's box
tuning instructions for
details.
15
Advertisement
Table of Contents
