Table of Contents
Advertisement
PROGRAMMI
NG TH E REMOTE
The universal remote can be programmed to control most brands of
remote controllable VCRs, satellite receivers and cable boxes. The
remote is already programmed to control most RCA, GE and PROSCAN
TVs, VCRs, DVD players, laserdisc players and satellite receivers.
TESTING
THE
REMOTE
To determine whether the universalremote needsto be programmed,
turn a device ON, suchas a VCR,point the remote at the VCR,and press
the VCR1 button. Then pressPOWERor CH ^ (channel up) or CH v
(channel down) to see if the VCR respondsto the remote commands.If
not, the remote needsto be programmed.
PROGRAMMING
TH E REMOTE
Using Automatic
Code Search
The following
instructions can be used to program the remote to
control each of the devices connected to your TV. If you want to exit the
automatic code search without
programming
any of your devices, press
CLEAR until the LED turns off.
1.
2.
.
Turn on the device you want to control (VCR, SAT, etc.)
Press and hold the button you want to program (VCR1, VCR2, etc.).
While holding the device button, press and hold ONoOFF until the
red light on the remote turns on, then release both buttons.
Pressand release PLAY,then wait 5 secondsor until the LEDstops
flashing.
At this point the remote is searching for the correct code to
program. If, after 5 seconds, the device you want to control does
not turn off, press PLAY again to tell the remote to search the next
set of codes.
Continue pressing PLAY until the device turns off or you have
searched through all of the codes. There are 20 total sets of codes.
If the device does not turn off after pressing PLAY 20 times, then
the remote cannot control that particular device.
If the device you want to control does turn off:
1.
Press and release REVERSE,then wait 2 seconds. Repeat thisstep
until the device turns back ON.
2.
To finish, press and t_old STOP until the red light on the remote
turns off.
Using Direct Entry
1.
Turn on the component to be programmed.
O<3
V(_z
AU_ IAToCAI_
m
STOP
_D
You'll use these buttons when you
program the remote to control any
device.
The remote may not operate all models
of all brands.
Advertisement
Table of Contents
