Table of Contents
Advertisement
STEP 4: PLUG IN THE TV
Plug the end into the wall outlet, matching
the wide blade of the plug
with the wide slot in the outlet. Be sure to insert the plug completely.
STEP 5: PLACE BATTERIES
IN REMOTE
•
Remove the battery compartment cover from the back of the
remote.
•
Insert fresh batteries. Make sure that the polarities (+ and -) are
aligned correctly.
•
Replace the cover.
STE P 6: TU RN ON TH E TV
PressTV on the remote, or press POWER on the TV itself.
Pressing the TV button not only turns on the TV, but puts the remote
into TV mode, so that the buttons on the remote will control TV
functions.
ON-SCREEN
PROGRAM
GUIDE
The TV is designedto bring up the GUIDE Plus+on-screen program
guide when you usethe TV button on the remote to turn on the TV
(after you have set up the GUIDE Plus+system).For more information,
seethe GUIDE Plus+Features & Setup booklet.
To get out of the Guide:
•
Press OK to tune to the highlighted channel.
•
Press GUIDE to tune to the channel displayed in the View window.
•
Press CLEAR to remove the guide from the screen and go to the last
channel you were watching.
STEP 7: PROGRAM
THE TV
Proceed to the next section, Interactive Setup. The interactive setup
routine walks you through the steps needed to fully configure the TV.
The first steps ask you to select your preferred language for the menu
system and to begin the auto channel search, which puts available cable
TV or antenna signals into the TV's memory.
Projection TV Convergence
if the picture appears to have a double or
triple image or if you notice rings or halos
around objects, you may have to adjust the
color convergence.
Details can be found
under the Screen menu heading in the
Features and Menus section of this manual.
10
Advertisement
Table of Contents
