Blank screen
•
Maybe the device connected to the input jacks is not turned on.
•
Try another
channel.
•
Press RESET,in case the picture controls are set too low.
No sound,
picture
okay
•
Maybe sound is muted.
Try pressing volume up button
to restore sound.
•
Maybe TV's speakers are turned
off.
Check the Audio Output
and Speakers control panel in the Audio
menu.
•
If using an S-VHS component,
remember to also connect the component's
L and R AUDIO OUT ja(:ks to the
TV's L and R INPUT 1 jacks.
Can't
select
certain
channel
•
Channel may be blocked or not approved
in the Parental Controls menu.
•
If using a VCR, check to make sure the TVNCR switch on the VCR is in the correct position.
Noisy
stereo
reception
•
May be a weak station.
Use SOUND button to change to mono mode instead of stereo.
No picture,
no sound
but TV is on
•
Maybe the cable/air function
is set to the wrong
position.
•
Maybe a vacant channel is tuned.
•
If watching
VCR (connected
only through
antenna
input), make sure TV is tuned to channel 3 or 4 - same as
CH3/4 switch on VCR. Also check to make sure TVNCR switch on VCR is in correct position.
Sound okay, picture poor
•
Check antenna connections.
•
Try adjusting
sharpness function
to improve weak signals.
Black Box appears
on the screen:
•
Captioning
may be turned
on. Check the Closed-Caption
Display control panel in the Channel menu.
TV GUIDE
Plus+
IR Controllers
not working,
I
t
Check to make sure the controllers
are positioned
correctly over the IR remote sensors.
Your remote may be interfering
with the IR controller.
Place a piece of dark tape over the IF[ controller.
TV GUIDE Plus+ control
of a cable box is slower than direct control of the box itself. Keep this in mind when
changing
channels.
7q