RCA E09303 Owner's Manual page 21

Table of Contents

Advertisement

Connecting Your TV
Mounting Your TV
10. (Optional) Attach Supplied
Antenna to Bottom of TV.
........
)
[.. .......
t
®
If you have attached the supplied dipole
antenna to the top of your TV, you will
need to attach it to the bottom of your
TV before mounting it. If you have
connected another type of antenna, skip
to step 11.
C) If the dipole antenna is attached to
the top of the TV, you can remove it
by grasping the base and lifting it
up and off.
Q
Insert the antenna base into the
pocketed slot on the bottom of your
TV. Press the base of the antenna
into the slot until it locks in place.
G'
Connect the ends of the twin-lead to
the antenna adapter (supplied).
(_
Connect the antenna adapter to the
round antenna connector on the
back of the TV.
Q
Later, after you have turned on the
TV, adjust the length and position
of the antenna for best reception.
• For viewing VHF channels 2-13,
extend the rods fully.
• For viewing UHF channels 14-69,
shorten the rods for best reception.
• For listening to the radio, if
necessary, adjust the antenna rods
for best reception.
U. Slide TV onto Bracket
Cabinet
Cabinet
Move TV completely
to rear of bracket.
Slide the TV onto the mounting hook of
the bracket and push it all the way back
until the two back hooks on the bracket
lock into the back of the TV.
Note: The TV must be slightly below the
cabinet overhang when installed in the
bracket. Some clearance is necessary so the
TV can be easily rotated to the desired
viewing angle or removed for portable use.
12. Attach AC Power Cord.
• First attach the AC power cord to
the 4-prong connector on the back
of the TV.
• Then extend the cord and plug it
into an electrical outlet.
13. Attach Cord Hooks.
• You can use the cord hooks to hold
the cord out of the way.
• For the most attractive appearance,
place the cord hooks at the back
edge of the cabinet (on or next to
the wall) directly above the outlet to
be used.
• To attach the cord hooks, peel off
the adhesive back and attach the
hooks to a clean, dry surface on
underside of cabinet or back wall.
• Use the cord tie that is attached to
the power cord to wrap and tie
Warning: Do not operate hot
appliances, such as fry pans,
toasters, coffee makers, etc. under
the TV when mounted above a
counter using the mounting bracket.
Excessive heat can damage cabinet
and may cause a shock hazard.
Cord
Hooks
AC Power
Electrical
Cord
Outlet 120-Volt
19

Advertisement

Table of Contents
loading

This manual is also suitable for:

E09304

Table of Contents