Philips DVDR600VR Owner's Manual page 13

E9480UD_EN.qx3 04.7.22 8:26 PM Page 13
Hookups (cont'd) 13
Connecting to a TV Only
TV has an S-Video In Jack
Back of TV
(example only)
Antenna or
CableTVSignal
4
5
7
Connect your Antenna or Cable TV signal to the ANTENNA IN jack
on the rear of the Recorder.
Connect an S-Video cable (not supplied) to the Recorder's S-VIDEO
OUT jack and to theTV's S-VIDEO In jack.
Connect the supplied audio cable to the Recorder's white/red
AUDIO OUT L/R (left/right) jacks and to the left/right AUDIO IN
jacks on theTV. Match the cable colors to the jack colors.
Connect the supplied RF coaxial cable to the (ANTENNA) OUT
jack on the rear of the Recorder, Connect the other end of the
same RF coaxial cable to the Antenna In jack on yourTV. Your TV's
Antenna In
jack
may be labelled RF In,Antenna In, or 75 ohm. Check your TV's
manual for derails.
Connect the power cords of the Recorder and theTV to a power
outlet.
Press STANDBY-ON O to turn on the Recorder. If"ISTV ON? C03"
appears on the display panel, you need to turn on yourTV and set it to the S-
Video In channel. (See next step.) You cannot see the Initial Setup screens until
you turn on theTV and have it on the correct S-Video In channel.
Turn on theTV power. Set theTV to the S-Video In channel, This is
not channel 3 or 4 when you are using S-Video. Your TV remote may have a
button or switch that selects the S-Video In channel. Or, go to your lowest TV
channel and change channels down until you see the DVD background picture
or Initial Setup screen on the T_. The Initial Setup screen will appear the first time
you turn on the Recorde_Go to page 18 to continue.
Helpful Hint I
|
• On the TV, the S-Video In jack I
may be labeled Y/C, S-Video,or I
S-VHS (super video). I