Table of Contents
Advertisement
Basic Connections
The progressive
scan video quality is only
available when using Y Pb Pr connection
and a progressive
scan TV is required.
It
provides superior
picture quality when
watching
DVD movies.
Use the component
video cables (red/
blue/green
- not supplied) to connect the
COMPONENT
VIDEO
OUT
(Y Pb Pr) jacks on the main unit to the
corresponding
component
video input
jacks (or labeled as Y Pb/Cb Pr/Cr or
YUV) on the TV.
[f your TV accepts progressive
signals,
proceed to chapter 'Getting
Started -
Setting up Progressive Scan feature' for
detailed progressive
feature setup.
If your TV has only a single Antenna Input
jack (labeled as 75 ohm or RF In,) you
will need an RF modulator
in order
to
view the DVD playback on the TV. See
your electronics
retailer
or contact
Philips for details about RF modulator
availability
and operations.
Use the supplied composite
video cable
(yellow) to connect the main unit's
VIDEO
OUT
jack to the video input
jack on the RF modulator.
Use an RF coaxial cable (not supplied) to
connect ANTENNA
OUT or TO TV jack
on the RF modulator
to the ANTENNA
IN jack on the TV.
Connect
the Antenna or Cable TV
service signal to the ANTENNA
IN or RF
IN jack on the RF modulator.
(k may
have been connected
to your TV
previously.
Disconnect
it from the TV.)
15
Hide quick links:
Advertisement
Table of Contents
