Mitsubishi CS-31505 Owner's Manual page 57

Setting the AN Network
_Important:
_Important:
_Important:
The A/V Network is a special system that Mitsubishi developed to
make it easier to operate many product_: with one remote control.
When the A/V Network is connected between two Mitsubishi
products, you can point the remote control at one product and it
will "pass" the remote control command to the other. To set up the
A/V Network:
First Time Set-Up
Set the clock
Memorize channels
Add/delete channels
I_ Set AJV Network
Use ADJUST to select.
Then press ENTER.
Press MENU to return to
TV Main Menu.
O
O
O
Set A,h/Network
Press the MENU button on the
remote control. The Main Menu
will .appear on the screen.
Use the ADJUST buttons to
seleet "First Time Set-Up."
Press the ENTER button.
Use Lhe ADJUST buttons to
select "Set A/V Network." Press
the ENTER button.
_, Off
Basic
Active
Use ADJUST to select.
Then press ENTER.
Press MENU to return to
First Time Set-Up Menu.
Use the ADJUST buttons to
select "Active," "Basic," or "Off."
Ciheck the rear terminals of
your VCR, then use the chart
below to determine how you
should set your TV.
Press the HOME button to
return to normal TV viewing.
If your VCR has a rear ...and you have set your ...then set your
terminal that reads: VCR 1_o: TV to:
A!V Network - Basic
Actiw,_ A/V Network Off Basic
Actiw_ A/V Network Active Active
Does not have an A/V
Network rear terminal - Off
If you are not sure how to set your VCR's A/V Network setting,
refer to your VCR's owner's guide.
If connected, the A/V Network can still be used to pass remote
control signals when the TV's A/V Network setting is "Off."
If you do not use the/_ Network system, set "A/V Network" to
"Off," or there may be problems selecting channels on your TV.
If you are using a Mitsubisbi VCR with A/V Network or Active A/V
Network, you should have connected it to the INPUT-:I of your TV.
58 Chapter 3: Operating Your TV