Fan Speed & Airflow Direction Adjustment - Mitsubishi Mr.Slim MSZ-GE06NA Operating Instructions Manual

FAN
Press _} to select fan speed. Each press changes
fan speed in the following order:
(AUTO) (Quiet) (Low) (Med.) (High) (Super High) I
• Two short beeps are heard from the indoor unit when set to AUTO.
• Use higher fan speed to cool/heat the room quicker. It is recommended
to lower the fan speed once the room is cool/warm.
• Use lower fan speed for quiet operation.
Note=
Multi system operation
When several indoor units are operated simultaneously for heating operation,
the temperature of the airflow may be low. In this case, it is recommended to set
the fan speed to AUTO.
VANE
Press _ to select airflow direction. Each press
changes airflow direction in the following order:
UTO) (1) (2) (3) (4) (5) (SWlN
• Two short beeps are heard from the indoor unit when set to AUTO.
(AUTO) ......... The vane is set to the most efficient airflow direction. COOL/
DRY:horizontal position. HEAT:position (5).
p
_4A (Manual) ....... For efficient air conditioning, select the upper position for
COOL/DRY, and the lower position for HEAT. If the position
(4) or (5) is selected during COOL/DRY, the vane automatically
moves to the horizontal position after 0.5 to 1 hour to prevent
any condensation from dripping.
(Swing) ......... The vane moves up and down intermittently.
[] To change the horizontal airflow direction.
Move the vertical vane manually before starting operation.
SMART SET
........................ Press _ during COOL, ECONO COOL, or HEAT
mode to select SMART SET mode.
Set the temperature, fan speed, and airflow direction.
• The same setting is selected from the next time by simply pressing
SMARTSB
[_--3.
, Two settings can be saved. (One for COOL/ECONO COOL, one for
HEAT)
• Select the appropriate temperature, fan speed, and airflow direction
according to your room.
• Normally, the minimum temperature setting in HEAT mode is 59°F
(t6°C). However, during SMART SET operation only, the minimum
temperature setting is 50°F (10°C).
SMARTSET
Press {_ again to cancel SMART SET operation.
• SMART SET operation also is cancelled when the MODE button is
pressed.
SMART SET operation
Asimplified set back function enables to recall the preferred (preset) setting with
. SMARTSET
a single push of the [_ button. Press the button again and you can go back to
the previous setting in an instance.
Example of use:
1. Low energy mode
Set the temperature 4°F (2°C) to 6°F (3°C) warmer in COOL and cooler in
HEAT mode. This setting is suitable for unoccupied room, and while you are
sleeping.
2. Saving frequently used settings
Save your preferred setting for COOL/ECONO COOL and HEAT. This ena-
bles you to select your preferred setting with a single push of the button.
En-6
i