Before You Call - Maytag MDB4000 User Manual

Hide thumbs Also See for MDB4000:
Table of Contents

Advertisement

Before
You Call ..................................................
Check these points to help save you time and money:
o•••••o••eo•o••meeo••_l•o••o_•
•••e••O•Oo•ooOe••e•e••oe•••,_•o•o_•eo••••ee••e••o'••eo|
Won't Fill
Won't Drain/Water
in Tub Bottom
I*m,,,o*lml_,_o*_a_o_.oi*ooQoQvvQQ**lJ*_•tto
Detergent
Cup Not Empty
Seems Noisy
Cycle Takes Too Long-
(Heating
Delay light stays on)
Has An Odor
Leaks
••OOeeOooeoo_oee•e_eeeooeo•eto_
, Be sure door is latched securely.
• Be sure the water is turned on.
• Check that the dial!pad is properly
selected for a cycle.
• Allow time for select models to drain/pause
before filling.
• Check your home's circuit breaker or fuse box.
• Check inlet hose for a kink.
• Check water valve inlet for sediment
and clean if necessary.
• If hooked
up to a food waste disposer, be sure the knock-out
is removed
from the disposer inlet.
• Be sure the drain hose is elevated at least 32" so water cannot siphon back
into the tub.
• Check for a food obstruction
in the drain or disposer.
• Check drain hose for a kink.
• Check your home's
circuit breaker or fuse box.
• Check that the cycle is completed.
];';omplete i . .........................................
• Be sure dispenser
is not blocked,
• Use fresh detergent
which has been stored in a cool, dry place.
• A water valve hiss during fill is normal.
• Water circulation
sounds are normal.
• A ticking noise is a normal timer sound.
• A thumping
sound may be a wash arm bumping an item that is extendin_
beyond the racks,
• Chopping
or grinding
sounds may be heard during drain as the intema
food disposer chops hard items like fruit seeds, nuts, etc.
• Humming
during drain is normal.
• A snap noise is the detergent
cup lid hitting the door liner when the dish,
washer door is opened at the end of the cycle. This is normal.
• Proper installation
affects the noise level.
• Temp Sense has been selected and the cycle is extended
if the water tern
perature is low. (See pg. 8)
• Check to see that the incoming water temperature
is 120-140 ° F (49-60 ° C)
• Dishes being held for a full load may need to be run through
a Rinse
Hold cycle while waiting.
• Many dishwashers
have a "new" smell when first installed.
It dissipate_
with use.
• A chemical
odor is usually the chlorine bleach in dishwashing
detergents
You may want to try another brand.
• Dishwasher
not draining properly. (See "Won't Drain" section.)
• Check that the dishwasher
is level, (Refer to the Installation
Instructions.i
• Suds can cause the dishwasher
to overflow. Measure the detergent car, full,.
and use only detergents designed for use in a dishwasher. Less detergent i:
needed in soft water. Try another brand if sudsing continues.
• Follow directions
closely on how to add a forgotten item (see pg. 9).
• To avoid rinse aid leaking from the dispenser, be sure the lid is _curely attached
• Occasionally
moisture droplets may be noticed on the door vent in the are_
where heated air escapes from the tub. This is normal. If the door is opene_
before the droplets have evaporated,
they may fall to the floor.
13

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Mdc4000Mdb4010Mdb4030Mdb4040Mdb4050Mdb5000

Table of Contents