Maytag 23-11-2242N-005 Instruction Manual page 4

Table of Contents

Advertisement

Available languages

Available languages

Maintenance
oooooooooooooooooooooooooooooooooooooooooooooooooo
Permanant
Drain
Installation
(optional):
The condesate water
can be removed directly
from the
unit to a drain through
a garden hose with the included
adapter.
1.
Unplug
unit before beginning
work.
2.
Use a screwdriver
to remove the knock-out
at the back
of the unit.
3.
Slide the garden hose adapter (supplied)
over the
condensate
drain through
the knock-out
hole.
4.
The garden hose should lead to a floor drain or other
appropriate
drain source.
The garden hose should
have no inclines or sharp bends.
Permanant
drain
Condensate
Drain
Hose Adapter
Garden Hose
Service
(Read carefully before calling for service)
If the
Dehumidifier
Fails
to Start
• Make sure the unit is plugged
into an operating
outlet.
• If the indicator
light (most models) is on, empty the full
water container.
The indicator
light should
now go OFF,
and the dehumidifier
will begin to operate.
If the
dehumidifier
does not begin to operate
make sure the
float is attached to the water container.
Unit
Runs,
But
Very
Little
Water
is Collected
• The amount of water removed from the airdepends
on
the relative humidity
of the air and the capacity of the
dehumidifier
purchased. When the air feels damp (high
relative
humidity),
more moisture
will be removed
and
the container
will fill up more rapidly. As the unit
continues
to remove moisture and reduce the humidity
in the area, less water
will be collected
in the container.
• Room humidity
is low (below 40%).
Sounds
It is reassuring to know that your dehumidifier
is
functioning
properly. These are some normal sounds which
should not be a cause for concern:
• Air rushing over air drying coils.
• Hissing or thumping
- refrigerant
is flowing
throughout
the sealed system and may generate
a "boiling"
sound
right after the compressor stops.
• Compressor
may "thump"
as it cycles on and off.
• Water dripping
from coils onto the drain plate.
• The humidistat
control,
compressor
and fan "tick"
as
they turn on and off. Metal
makes a similar sound when
expanding
or contracting.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents