Table of Contents
Advertisement
Remove the
refrigerator
door
Pass the
refrigerator
Before
installation
Warning
3) Remove keeper by rotating it clockwise (@)
and then remove the upper hinge by lifting it
up(®).
Keeper
4) Removethe refiigerator compartment door by
lifting it up.
Lower EtJnge
Passthe refrigerator laterallythrough the access
door as shown in the right figure.
Mount the freezer and refrigerator
compartment
doors
Mount them in the reverse sequence of removal after they pass through the access
door.
Feed water pipe Installation
• Automatic ice maker operation needs water pressure of 147-834 kPa
(1.5-8.5 kgf/cm _)(That is, an instant paper cup (180 cc) will be fully filled within
3 sec.).
• If water pressure does not reach the rating 147 kPa (1.5 kgf/cm 2)or below, it is
necessary to purchase a separate pressure pump for normal automatic icing and
cool water feed.
• Keep the total length of the feed water pipe tube within 12 m and be careful for the
tube not be bent straightly. If the tube is 12 m or longer it may cause trouble in
water feed owing to the drain water pressure.
• Install the feed water pipe tube at a place free from heat.
• Connect to potable water supply only.
Advertisement
Table of Contents
