Panasonic Digital Palmcorder PalmSight PV-DV910 Operating Instructions Manual page 31

You can control any two PV-DV910's
with one Remote control. In order for the
remote to distinguish between the two
units, it is necessary to set one of the
Palmcorders to VCR 2. On the remote,
press VCR 1 or VCR 2 to control the
desired Palmcorder.
For VCR 2 : /_ ._,,_
Press these ,-=
buttons at
same time.
Display the menu and select REMOTE
VCR 2 on one Palmcol:der (see page
18). Leave the other Palmcorder set to
VCR1.
Set the Remote Control to VCR 1 or
VCR 2 to correspond with the Palm-
corder you wish to control. (See
illustration at left.)
Note:
• When the Palmcorder and remote are
not set to the same mode (VCR1 or
VCR2), "CHECK REMOTE MODE" will
appear.
For VCR 1 :
:_'Press these
REMOTE
buttons at
same time.
• After replacing the Remote Control
Battery, the remote will default to VCR 1.
1
Insert a slender, pointed
object, such as the tip of a
ball-point pen into the slot so
that it fits into the hole (as
shown a). Then, while sliding
to the right, pull the battery
holder out with your fingernail.
2
Insert the battery into the
BatteryTray with the ® mark
facing up.
Do not reverse the polarity.
Replace the Battery Tray.
rReplace battery with
Panasonic PART NO.
VSBW0004 (CR2025) only.
Use of another battery may
present a risk of fire or
explosion.
Caution-battery may
explode if mistreated.
Dispose of used battery
promptly. Keep away from
children. Do not recharge,
disassemble or dispose of
in tire.
For assistance, call 1-800-211-PANA(7262)
31