Panasonic TC-L32C12 Operating Instructions Manual page 39

Automatically searches and adds available channels to the memory,
_ Select "ANT in" (3) Select a scanning mode (p. 16)
÷ Select Cable or Antenna
Or select "Not used". (p. 16) ,,ok
(_ Select "Auto program"
select
-(2]next
-@select
Settings are made automatically
® After the scanning is completed, select "Apply".
(see below ®).
® All previously saved channels are erased.
Use this procedure when changing the channel setup or
changing the channel display.
Also, use this to add or skip channels from the channel
list manually.
You can select a channel tuning mode (Digital only/
Analog only) in "Channel surf mode"(p. 28)
(1_Select "Edit"
Select the item to be edited
Caption Add Changes the station identifier
Favorite:
Registers channel to Favorite
List
÷ Add:
R e Adds or skips channels
_ __Proceed to next page
Go back to previous page
Edit
® Caption
set/next
BmB
DDD
or
UOD
m
Select or edit the station identifier.
(maximum 7 characters available)
® Favorite
select
Set favoriteJ Select the number
® Add RErURN
Press OK to select "Yes (add)" or "No (skip)"
@ Move cursor to channel number
®
Cr d_se ect
_ _ , .... "Apply"
@ok
To cancel the Edit
Check the signal strength if an interference is found or freezing occurs on a digital image.
_BD
DDm
BDD or
Signal intensity
® If the signal is weak, check the antenna.
If no problem is found, consult your local dealer.
® Not available if "Cable" is selected in "ANT in"
(see above).
® Available only for digital antenna channels.
® If "Lock" (p. 36) is activated and "ANT/Cable setup" is selected, "Enter password." will be displayed.
@
m
m,
tm
b0
_q.
tm
C)
,m
7
39