LG MFL39817402 Owner's Manual page 15

Operating Instructions
The up/down airflow (Vertical airflow) can be
adjusted by using the remote controller.
1. Press the START/STOP BUTTON to start the
unit.
2. Press CHAOS SWING BUTTON.
3. The louvers will swing up &
down automatically.
4. To stop the louver at a desired
angle, press _J!!-_again
-%
The left/right--Horizontal airflow)can be adjusted *_
by using the remote control.
1. Press the START/STOP BUTTON to start the
unit. 1,,
2. Press the HORIZONTAL AIRFLOW Q
DIRECTION BUTTON. _
3. The louvers will swing left & __" [
right automatically. __
4. To stop the louvers at a desired_ilb _
angle, press (_ again.
• By pressingthe CHAOS SWINGBUTTONthe horizontalair flowdirectionis changedautomaticallybased on the chaos
algorithmto distributethe air in the roomevenly and at the same time to makethe human bodyfeel most comfortableas if
enjoying naturalbreeze.
• Always use the remote controllerto adjustthe up and downair flow direction.Manuallymovingthe vertical air flow
directionlouver by handcoulddamage the mechanism.When the unit is shut off, the up/downairflowdirectionlouver will
closethe air outletvent of the system.
This operation circulates the air without cooling or heating. It can
be activated by pressing the AIR CIRCULATION BUTTON. Once
the air circulation is activated you can select the air speed by
pressing the INDOOR FAN SPEED SELECTOR BUTTON.
+
CHAOS Air economizes power consumption and prevents overcooling. The fan speed is automatically
changed from high to low or vice versa, depending on the ambient temperature.
• In case of inverter type models where there is no AIR CIRCULATION BUTTON, air circulation can be
operated by pressing the PLASMA BUTTON.
f_ in the situation of power failure.
When power regains after a failure this feature restore the previous operating condition
and the air conditioner will run in the same settings.
This feature is enabled by factory default setting, but you can disable it
by pressing the ON/OFF button for 6 seconds. The unit will beep twice
and the indicator lamp(2) will blink 4 times.
To enable it, press the button again for 6 seconds. The unit will beep
twice and the indicator lamp(l) will blink 4 times.
Owner's Manual 15