LG MFL39817402 Owner's Manual page 13

Operating Instructions
i
_ing automatica!ly deEnergy-saving c ooling mode can save energy in cooling and healthy dehumidification operation, because it
an operate efficiently by setting body-adaptation time according to the change of time and temperature and
J
sired temperature.
1. Press the START/STOP BUTTON to start the unit.
2. Open the door on the remote controller.
Select cooling operation or healthy dehumidification operation.
3. Press the ENERGY-SAVING COOLING MODE BUTTON.
4. To cancel the energy-saving cooling mode, press the ENERGY-SAVING
COOLING MODEL BUTTON again and unit will operate in previous
mode(Cooling or healty dehumidification mode).
The Display Luminosity can be adjusted by using the remote control.
Press the start/stop button to start the unit. Open the door on the remote control, press the 2ndF button
and, press display luminosity button.
Display will be dark. Press the button again to set bright display.
Operation procedures when the remote control can't be used.
The operation will be started if the ON/OFF button is pressed.
If you want to stop operation, re-press the button.
Cooling Model
Operating mode Cooling
Indoor FAN Speed High
SettingTemperature 22°C(71.6°F)
Room Temp. _> 2 4°C(75.2°F)
Cooling
High
22°C(71.6°F)
Heat pump Model
21°C(69.8°F) _< R oom T emp. <24°C(75.2°F)
HealthyDehumidification
High
23°C(73.4°F)
Room Temp. <21°C(69.8°F)
Heating
High
24°C(75.2°F)
Test operation
During the TEST OPERATION, the unit operates in cooling mode at high speed fan, regardless of room
temperature and resets in 18 minutes.
Duringtest operation, if remote controller signal is received,the unit operates as remote controller sets.
If you want to use this operation, Press and hold the ON/OFF button for 3-5 seconds, then the buzzer sound
1 "beep".
If you want to stop the operation, re-press the button.
Owner's Manual 13