Panasonic Omnivision PV-9455S Operating Instructions Manual page 5

1
Between ANT, and VCR
• Case 1: Twin Lead Cable Only
To VCR Terminal
From Antenna
_
3C0-75 ohm
(Flat) Twin Lead Transformer
300 Ohm Cable (notsupplied)
• Case 2: Twin Lead & Coaxial Cables
(notsuppli_
coaxial Cable
To VCR Terminal
• Case 3: Two Twin Lead Cables
UHFNHF Band Mixer
(notsupplied)
300-75 ohm
Transformer
(notsupplied)
To VCR Terminal
• If your TV has both post and plug*typp
VHF terminals, the po_t connectionis
recommended to minimize signal loss.
Between VCR and TV
f
• Case 1: Screw & Plug Type Terminal
UHFNHF Band _ TV
Separator
RF Coaxial Cable
• Case 2: Screw Type Terminal
75-300 ohm
Transformer
(not supplied)
• Case 3: Double Screw Type Terminal
UHFNHF Band TM
Separator
(not s_VHF
• Case 4: Complex "rv Terminal
TERMINALS ON BACK OF TV SET
Split out _--_ _
ANT2
• Connect to one of the ANT terminals and
select the same antenna number on the "iV.
5