Panasonic OmniVision PV-C2060 Operating Instructions Manual page 47

F
DISPLAY =
Rec Time Remaining
(OTR mode only,
page 13.)
Receivable
Types (See page 1 1.)
To display or remove the
overlay.
Press DISPLAY.
Function Status Channel Caption
Current Time
I
RI_C 12 : 0 0PM ABe
• o: 25 -0; 12: 34--F--_ Counter
_SAP{_STEREO K-
SP_T
MONO ape Speed
Time Stamp Data (See pages 30, 31.)
Whenever a blank section of a tape
comes up in Play mode, or when the
selected channel has no broadcast
signal with the "Weak Signal Display
ON/OFF" (see page 32) set to "OFF,"
the TV screen will turn solid blue.
When a function button is pressed
(PLAY, FF, etc.) or you change channels,
the unit mode or channel number will be
displayed,
(Some station names may also appear if
Channel Caption is set. See pages 28, 29.)
O8
ABe
Warning and Instruction Displays These displays will alert you of a missed
operation or provide further instructions.
NO CH FOUND PLEASE CHECK
ANTENNA CABLE CONNECTION THEN
PUSH CH UP KEY AGAIN
• If no active channels are found for CHANNEL MEMORY...
PLEASE SET CLOCK BEFORE • If you attempt to set or review a Timer Recording, VCR Plus+
PROGRAMMING System Programming or set the On-Timer and the Clock is not set...
CHECK CASSETTE RECORD TAB - If you press REC, and a cassette is inserted with no record tab...
TO CANCEL TIMER REC HOLD DOWN ° If you press STOP during a Timer Recording...
STOP KEY FOR APPROX 3 SEC
NO CASSETTE • If you press PLAY, FF, REW, or REC without a cassette inserted...
PLEASE INSERT A CASSEI-rE
REMOTE CONTROL IS SET • If you press POWER, ACTION, or PROG on the remote while in
TO DSS/CABLE MODE DSS or CABLE mode...
USE COMBO : COMBO KEY
VIDEO HEADS MAY NEED CLEANING • If head cleaning becomes necessary while playing back a tape...
PLEASE INSERT HEAD CLEANING
CASSE'T'rE OR REFER TO MANUAL 48
END: PLAY KEY
VCR LOCK ACTIVATED • If you press a function button other than STOP/EJECT or POWER 32
while the unit is in VCR Lock mode...
47
7
8, 9,46
6, 13
15
12, 13
42, 43