Panasonic OmniVision PV-C2060 Operating Instructions Manual page 42

Find your DSS box or Cable box Brand
Code Number from one of the charts on the
next page.
2
®
and
GD_
Setup remote.
1) Hold down DSS CABLE.
! 2) Press NUMBERED keys to enter code.
• For code 100 or greater, first press 100 key, then
I the remaining digit. E.g. for 102, press 100, then
i
press 0, and then press 2.
Confirm code entry.
O i Press POWER* t° turn
selected unit ON or OFF.
• See below for a list of controllable
functions in each mode.
• Please repeat the Universal Remote Control Setup after replacing
remote control batteries.
• The remote control will not operate all DSS receivers or Cable Boxes
made by the manufactures listed. If you get no results, your particular
brand cannot be controlled.
Once the remote control has been
properly
set up, you can select
COMBO, DSS or CABLE mode depending on which functions you
wish to control.
(See below.)
Press COMBO or DSS CABLE
Q _ on the remote control to select the
or
desired mode. (See below for buttons
available in each
mode.)
Universal Remote Control is..,
The remote control may be set up to
control some basic DSS or Cable box
functions.
Set to COMBO:
• All TV and VCR functions.
_S_et t o DSS CABLE:
• Basic VCR functions, e.g. PLAY, REC, etc.
• CABLE/DSS functions, e.g. POWER, ENTER, NUMBERED
keys (except lOOkey), CH UP/DOWN
O
• In DSS or CABLE mode, it may be necessary to pressENTER after
pressing NUMBERED keys for channel selection.
• In DSS or CABLE mode, POWER, CH Up/Down, NUMBERED Keys,
ACTION, PROG/VCR+, DISPLAY, SEARCH, R-TUNE, FM/TV,
or ADD/DLT are not available. Press COMBO to use these functions•
• Depending on your DSS receiver or Cable box brand, some of the
functions listed may not be remote controllable.
• Some DSS receiver or Cable box brands require you to turn on the
power manually.
• Due to changes in infra-red commands used by manufacturers, some
brands have several codes. If your unit does not respond to the first
code, please try the next one.