Table of Contents
Advertisement
ASSEMBLY
SEAT INSTALLATION
1. Attach seat and seat plate to seat support bracket with two
5/16-18 shoulder bolts end two hex head Iocknuts. Tighten
securely (FIG. 3A-ASSY).
CHUTE DEFLECTOR ASSEMBLY
1. Place discharge
chute deflector onto tractor deck
(FIG. 4-ASSY).
2. Slide smoothend of pivotrod throughrear tab on chute
deflector and rear mounting brackettab (expose approxi-
mately 2 Inches of pivot rod).
3. Spreadspringopenwitha twisting motionand place onto
pivot rodwithbentendof spring as closeas possibleto rear
mounting bracket taband overchute deflector.Straight e nd
of springshouldbe towardfronttab of chutedeflectorand
overmowerdeck (RG. 4-ASSY Inset).
4. Tap grooved and ofpivotrod(as Indicatedby snow) with
a hammeruntilrodisflushwithreartab onchutedeflector.
S. Install push nut on end of pivot rod (FIG. 4-ASSY inset).
2. Connect seat switohto wire harnass. NOTE: If seat switch is
not connected to wire harness, engine willstop when mower
clutch lever is engaged (FIG. 3B-ASSY).
3. Attach wire harness to seat plate with press clip.
I_VOT
Roo
CHUTE DEFLECTOR
TORSION SPRING
MOWERDECK
REARTAB
REAR MOUNTING
BRACKET TAB
STSAIGHT
END OF
SPRING
LE_'_OR
FRONT
CHUTE DEF
MOUNTING
BRACKET
TAS
PUSH
FRONTTAB
NUT
INSET - TORSION SPRING INSTALLATION
TO ADJUST QUICK ADJUST SEAT
(FIG.3C-ASSY)
If adjustment Is needed:
1. Move seat adjust lever to the left and hold, while movingseat
forward or rearward to desired operator's position. Release
seat adjust lever.
NOTE: Make sure lever latches in slot.
MOWER
DECK WHEEL ASSEMBLY
1. Attach mower deck wheels to deck wheel mounting brackets
with wheel axle bolts and 3/8 inchIocknutsas shown in (FIG.
4A-ASSY). NOTE: Use top hole on both rightand left wheel
mounting brackets as shown in (FIG. 4A-ASSY).
NOTE:
If more adjustment is necessary see Mower Deck
Wheel Adjustment in the Adjustment sectldn of this manual.
f
AXLE BOLT
12
Advertisement
Table of Contents
