Dell Alienware Aurora R3 Manual page 37

Desktop manual
Hide thumbs Also See for Alienware Aurora R3:
Table of Contents

Advertisement

Before Working Inside Your Desktop
Use the following safety guidelines to help protect your desktop from potential
damage and to help to ensure your own personal safety.
WARNING: Before working inside your desktop, read the safety
information that shipped with your computer. For additional safety best
practices information, see www.dell.com/regulatory_compliance.
CAUTION: Handle components and cards with care. Do not touch the
components or contacts on a card. Hold a card by its edges. Hold a
component such as a processor by its edges, not by its pins.
CAUTION: Only a certified service technician should perform repairs on
your desktop. Damage due to servicing that is not authorized by Dell is
not covered by your warranty.
CAUTION: To avoid electrostatic discharge, ground yourself by using a
wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on the back of the computer).
CAUTION: When you disconnect a cable, pull on its connector or on its
pull-tab, not on the cable itself. Some cables have connectors with locking
tabs; if you are disconnecting this type of cable, press in on the locking
tabs before you disconnect the cable. As you pull connectors apart, keep
them evenly aligned to avoid bending any connector pins. Also, before
you connect a cable, ensure that both connectors are correctly oriented
and aligned.
To avoid damaging the desktop, perform the following steps before you begin
working inside the desktop.
1.
Ensure that the work surface is flat and clean to prevent the side panel from
being scratched.
2.
Turn off your desktop (see "Turning Off Your Desktop" on page
CAUTION: To disconnect a network cable, first unplug the cable from
your desktop and then unplug the cable from the network device.
3.
Disconnect all telephone or network cables from the desktop.
4.
Disconnect your desktop and all attached devices from their electrical
outlets.
5.
Press the power button to ground the system board.
CHAPTER 4: INSTALLING ADDITIONAL OR REPLACEMENT COMPONENTS
34).
35

Advertisement

Table of Contents
loading

Table of Contents