Setting Up The Monitor; Attaching The Base; Connecting The Monitor; Connecting The Blue Vga Cable - Dell ST2210B User Manual

Back to Contents Page

Setting Up the Monitor

Dell™ ST2210B/ST2310B/ST2410B Flat Panel Monitor User's Guide
Attaching the Base
Connecting the Monitor
Attaching the Soundbar (Optional)
Removing the Base

Attaching the Base

NOTE: The base is detached when the monitor is shipped from the factory.
Complete the following steps to attach the base.
1. Place the monitor on a soft cloth or cushion.
2. Attach the base to the monitor.
3. Tighten the screw located below the stand.

Connecting the Monitor

CAUTION: Before you begin any of the procedures in this section, follow the
To connect your monitor to the computer perform the following steps/instructions:
1. Turn off your computer and disconnect the power cable.
2. Connect the HDMI cable, white (digital DVI-D), or blue (analog VGA) display connector cable to the corresponding video port on the back of your
computer. Do not use all the cables on the same computer. Use all of the cables only when they are connected to different computers with appropriate
video systems.

Connecting the blue VGA cable

Connecting the White DVI Cable*

safety instructions.