Setting Up The Monitor; Attaching The Base; Connecting Your Monitor; Connecting The Blue Vga Cable - Dell S1909WFP User Manual

Back to Contents Page

Setting Up the Monitor

Dell™ S1909W Flat Panel Monitor User's Guide
Attaching the Base
Connecting the Monitor
Attaching the Soundbar (optional)
Removing the Base

Attaching the Base

NOTE: The base is detached when the monitor is shipped from the factory.
After placing the monitor panel on a soft cloth or cushion, complete the following steps to attach the base.
1. Place the monitor on a flat surface.
2. Attach the base to the monitor.

Connecting Your Monitor

CAUTION: Before you begin any of the procedures in this section, follow the
To connect your monitor to the computer perform the following steps/instructions:
1. Turn off your computer and disconnect the power cable.
2. Connect either the white (digital DVI-D (optional)) or the blue (analog VGA) display connector cable to the corresponding video port on the back of your
computer. Do not use both cables on the same computer. Use both the cables only when they are connected to two different computers with
appropriate video systems.

Connecting the blue VGA cable

Connecting the white DVI cable (optional)
safety instructions.