Setting Up The Monitor; Attaching The Base; Connecting The Monitor; Connecting The Blue Vga Cable - Dell IN2020 User Manual

Back to Contents Page

Setting Up the Monitor

Dell™ IN2020/IN2020M monitor User's Guide
Attaching the Base
Connecting the Monitor
Attaching the Soundbar (Optional)
Removing the Monitor Stand

Attaching the Base

NOTE: The stand is detached when the monitor is shipped from the factory.
After placing the monitor panel on a soft cloth or cushion, complete the following steps to attach the base.
1. Fit the groove on the back of the monitor to the two tabs on the upper part of the stand.
2. Lower the monitor so that the monitor mounting area snaps on to or locks on to the stand.

Connecting the Monitor

CAUTION: Before you begin any of the procedures in this section, follow the
To connect your monitor to the computer perform the following steps/instructions:
1. Turn off your computer and disconnect the power cable.
2. Connect the white (digital DVI-D), or blue (analog VGA) display connector cable to the corresponding video port on the back of your computer. Do not
use all the cables on the same computer. Use all of the cables only when they are connected to different computers with appropriate video systems.

Connecting the blue VGA cable

Connecting the White DVI Cable* (for IN2020M only)
safety instructions.