Advertisement
A
our TV remote can be set to
work your VCR by what is
called the SEARCH
method.
If the "REMOTE
CODE"
number
method shown
in the previous
section did not set your remote to
work your VCR, then follow
the
five easy steps listed below.
Please read through steps 1-5
before beginning.
l BEGIN
1
/<.;-,,,,
'_.t_
Press the POWER button on
the VCR to turn VCR ON.
_22_
Stand at least six feet away
from the front of the VCR.
Point the remote toward the
VCR.
HOLD DOWN the MCH and
VCR System buttons at the same
time. KEEP HOLDING
BuTroNs
DOWN.
_ _,,_ Watch the Channel Indicator
on the VCR.
Channel Numbers will SCAN UP
when the VCR has been
identified. This may take up to
two minutes.
Release the A/CH and VCR
System buttons as soon as
channel numbers start to scan up.
The VCR code has been identified
and the remote is ready to operate
the VCR.
•
4t
__tw
Remember. A minute or
o can seem very long, but
the code should be located within
two minutes.
Don't let the VCR scan up more
than five channels. If you do the
remote may pass up the right code
and another two minute search
cycle will have to be repeated.
If no ,':hannel change happens
within two minutes, repeat steps
1-5. Should a channel change still
not occur, the remote will not
work with the desired VCR.
VCR
09
Don't let the VCR ,scan up
more tla_ five channels
(in Se_-ch mode).
T
Six Feet
(minimum)
lliiii
28
Advertisement
