Table of Contents
Advertisement
Connecting
the DVD Recorder with a Cable Box
Power cord to the
DVD Recorder%
MAINS jack and
to a power outlet
Audio and Video cables to the
DVD Recorder's red/white
AUDIO
OUT 2 and
yellow VIDEO (CVBS) OUT 2
acks and to the TV s
AUDIO
and V DEO IN iacks
RF coaxiai cable to the
OUT jack of the Cable Box
and "cothe DVD Recorder s
ANTENNA
iack
To front of Cable Box
(not used with Satellite
I
Connect
the Cable TV signal to the IN jack on your Cable Box. The IN jack may be labelled differently. See the
' Cable Box owner's manual for details.
Connect
an RF coaxial
cable to the OUT
jack of the Cable Box and to the ANTENNA
jack on the rear
of the DVD
Recorder.
The OUT jack may be labelled RF OUT, TO TV, or ANTENNA
OUT. See the Cable Box
owner's
manual for details.
Connect
the supplied
video cable (with
yellow
markings)
to the yellowVIDEO
(CVBS)
OUT
2 jack of
the DVD
Recorder
and to theVIDEO
IN jack on your TV.
Connect
the supplied
audio
cable(s)
(with
red/white
markings)
to the red/white,
right/left
AUDIO
OUT
2 jacks on the Recorder
and to the TV's
right/left
AUDIO
IN jacks.
Match the cable colors to the jack colors.
You will need the G-Link cable in order to use the GUIDE Plus+ _ System. Connect
the supplied
G-Link
cable to
the G-LINK
jack on the rear of the DVD
Recorder.
(Remove the Demo
Pin first if it is still attached to the G-
LINK jack.) Place the sensor of the G-Link cable in front of the Cable Box so it faces the remote sensor of your Cable
Box. The G-Link cable's sensor should be within
one inch of the front of your Cable Box.
Connect
the supplied
power
cord to the MAINS
(AC
Power)
jack on the rear of the DVD
Recorder.
Connect
the power
cords of the DVD
Recorder,
Cable
Box,
and TV to a power
outlet.
The first time you connect the DVD Recorder's
power cord, the features of the Recorder
will scroll across the display
panel on the front of the Recorder.This
will stop when you turn on the DVD Recorder's
power.
' Press STANDBY
0 to turn
on the DVD
Recorder.
Set the DVD
Recorder
to channel
3 or 4 (the output
channel
of your Cable
Box).Turn
on the TV and set it to the correct
Audio/Video
In channel.
You should see the Initial
Setup
menu
on theTV
screen the first time
you turn
on the
DVD Recorder.
Go to pages 4-5 of this Quick-Use
Guide to set up the
DVD Recorder
for
the first time.
2
Advertisement
Table of Contents
