Magnavox VRT344 Owner's Manual page 38

With a Converter/Descrambler Box
Cable Converter Box
Cable Input
With this connection, you can record and view
any channel, including scrambled channels.
However, channel selections must be made at
the cable converter box. This means that:
O
You can record any channel by using the
your remote control to select channels on
the cable converter box (see "Cable
Converter Box Code Setting" on page 34).
O
Timer recordings are programmed differ-
ently than shown on pages 20 - 25.
• You can only program a timer recording
for one channel at a time.
• When you are prompted to enter the
channel you want to record, select chan-
nel 3 or 4 (whichever is the output
channel of your cable converter box).
• Set your Gable converter box to the
channel you want to record.
• Leave the cable converter box on while
y._u are recording.
O You cannot view a channel other than the
one you are recording (the instructions on
page 17 do not work with this hookup).
• You cannot program channels with this
hookup (as discussed on pages 7 and 26).
ANT. IN
Jack
RF OUT Jack
Back of TV
Panel
Recording and Viewing a Scrambled
or Unscrambled Channel
1
With the VCR on and in VCR position, use the CHANNEL
(Up/Down) buttons to set the VCR to the output channel of
the cable converter box (channel 3 or 4).
2
Set the TV to the same channel to which you set the VCR.
3
Select the channel you want to record at the cable converter
box.
Watching TV With the VCR Off
1
Use the TV channel selector to set the TV to the same channel
as the output channel of the cable converter box.
2
Use the cable converter box channel selector to select the
channel you want to watch.
1 To program a timer recording with this hookup, see "Timer
recordings are programmed..." above left.
The cable converter box must be on during recording.