Setting The Clock - Magnavox VRT245AT Owner's Manual

10
Setting the Clock
Follow the steps below to set your
VCR's clock. Make sure:
:-: The VCR is on and in VCR posi-
tion (see page 12).
-You make each entry within 60
seconds of the previous entry (oth-
erwise, the VCR will exit Clock
Set mode and you will have to
start over).
Press the MENU button to bring up
the main menu display.
SELECT PUSH NO, SHOWN_'_
ROGRAM |
VCR SET UP 1
TUNER SET UP |
CLOCK SET |
DAYLIGHT SAV. TIME J
/
END PUSH MENU j
__ ,..
Press two Number buttons for the
month, two Number buttons for the
day, and two Number buttons for the
year. For example, for July 1, 1995,
press 07, 01, 95. The day of the
week will appear automatically.
TIME 02:15 PM
DATE 07101195 |
SAT.
/
TO CORRECT PUSH CLEAR
TO END PUSH MENU J
Press the MENU button to start the
clock. The screen will return to the
program you were watching.
Press the Number 4 button to select
CLOCK SET.
I-I
DATE - "- I'- - I- -
TO END PUSH MENU
Press two Numbor buttons for the
hour(s) and two Number buttons for
the minute(s). Then press 1 for AM
or 2 for P¢¢I. For example, for 2:15
PM, press 02, 15, 2.
I TIME 02:15 PM
_Ot, rrH_- ,'r.--/- - l
TO CORRECT PUSH CLEAR //
TO END PUSH MENU j
STATUS Button -_
CLEAR Button
MENU Button
Number Buttons_
e®®l
®®®1
D
• or * • • ••l _ e•eootoQooo•eQeooooo•oo••eoo•t • ••e
• To reset the clock, follow the steps
above.
• To display the time, press the STATUS
button. A status display, which
includes the time, will appear on-
screen. For details, see "On-Screen
Displays" on page 11.
• Power failures for more than three
seconds can cause you to lose your
clock setting as well as programmed
channels. If this happens, follow the
steps on pages seven and ten.
• If the numbers
entered do not match
the VCR's internal calendar, the entry
will be rejected and a question mark
(?) will appear on-screen.
• If you press the MENU button while
you are setting the clock, the on-screen
will return to the program you were
watching• If this happens, start over.
• To make corrections when setting the
clock, press the CLEAR button until the
number you want to correct is flashing.
Then enter the correct number.