Download Print this page

Sears 580.40378390 SERIES Owner's Manual page 5

13" tabletop color television with remote control

Advertisement

ANTENNA
CONNECTIONS
The best possible picture on this television receiver depends to a great degree upon an
antenna that delivers the signal to your "IV. The properly installed outdoor TV antenna
assures you of the best possible picture in your reception area.
Your local Sears store can inform you of the best outdoor antenna for your area. If you
intend to use a previously installed outdoor antenna, Sears strongly urges that you either
inspect your antenna or have it inspected for the weathering
effects of wind, snow, ice
and corrosion that greatly reduce the efficiency of the antenna and lead in cable.
INDOOR ANTENNA
1. Insert the Rod antenna into the hole located on the upper side of the set.
Connect the 300 ohm flat wire to the 300 to 75 ohm antenna adaptor.
2. Connect the 300 to 75 ohm adaptor to the antenna terminal.
OUTDOOR ANTENNA CONNECTION
Using a Combination VHF/UHF Antenna with a 75 ohm Lead-in Cable
• Connect the lead-in cable directly to the antenna terminal on the back of the IV.
Rod
Antenna
Coaxial
Cable
BACK OF TV
The 300 to 75 ohm antenna adapter is provided, as an accessory, when you purchase
this TV set.
CABLE TV (CATV) CONNECTION
Your -IV should tune in most of the cable channels without a converter box. This IV
is
designed to receive a total of 181 channels. Consult your local cable TV company for
additional information.
When using the cable "IV system, select the CABLE mode by using the FUNCTION
or
SET-UP button and VOLUME +(up)/-(down) buttons.
Cable Converter/Descrambler
box is not used.
75 ohm cable (from CATV company)
Cable TV
converter/descrambler
Cable Converter/Descrambler
box is used.
I
(fromCATV company)

Advertisement

loading