Assembly - LIFESTYLER ST210 User Manual

ASSEMBLY
Place all pads of the stepper in a cleared area
and remove the packing materials, except the tape
securing the sensor wire to the top of the upright (see
assembly step 6). Do not dispose of the packing
materials until assembly is completed.
ASSEMBLY REQUIRES THE FOLLOWING TOOLS:
• One (1) phillips screwdriver
• One (1) adjustable wrench
• One (1) rubber mallet
• One (1) allen wrench (included)
PART CHART
Use the drawings below to identify the small pads used
in assembly. The number in paranthesis below each
drawing refers to the key number of the part. The
second number refers to the quantity used in
assembly. Note: Some small parts may have been
•pre-attached for shipping purposes. If a part Is not
• found In the parts bag, check to see If It has been
pre-attached.
@
5/8" Cylinder Spacer (12)-2
21mm Washer (14)-2
20ram Lock Washer (32)-2
5/8" Dome Cap (11).-2
M8 Nylon Locknut (23)-2
©8
M 10 Nylon Locknut (24)-4
M10 x 1.5mm Screw (9)-2
M 10 Plate Screw (25)-2
M8 x 90mm Bolt (22)-2
M4 Screw (30)-4
M5 Screw (31)-2
#8 x 112"Screw (3)-4
M4 Bracket Screw (13)-2
4
1. Be sure that there is an Endcap (15) on each end of the
Stabilizer (21). Note: The Endcaps may need to be rotated so
that they are flat against the floor.
Attach the Stabilizer (21) to the saddle on the Base (20) with the
two M8 x 90mm Bolts (22) and M8 Nylon Locknuts (23).
15 23