Handle Removal; Handle Installation; Removing And Replacing; Refrigerator Doors - LG LSC27925 Series Owner's Manual

HANDLE REMOVAL REMOVING AND REPLACONG REFROGERATOR
You may have toremove t hedoorhandles tomove the DOORS
refrigerator through a narrow opening. SeeinstructionsBefore r emoving thedoors, remove thebase grille. See
below. "Base G rille Installation" forreference.
NOTE: Toavoid damaging doorsurfaces when moving
the refrigerator through narrow openings, it is
ALWAYS recommended toremove thedoors as
instructed inthenext t wopages.
• Loosen t hesetscrews witha 3/32"(2,38ram) A llen
wrench a ndremove thehandle.
NOTE: I f the handle mounting f asteners need to be
tightened ormoved, use a1/4"(6,35 ram) A llen
wrench.
Toremove theright(refrigerator} door:
1.Open thedoor. R emove thetophinge cover s crew (1).
2.Usea flatbladescrewdriver to pryback the hooks
(notshown) ofthehinge cover (2)from thetopofthe
refrigerator cabinet. Liftupthecover.
3.Rotate t hehinge lever ( 3)clockwise. Liftthetophinge
(4)freeofthehinge lever l atch (5).
NOTE: Regardless of hinge lever t ype, r emoval process
isthesame.
Set
4. Lift the door from the lower hinge pin.
5. Place the door, inside facing up, on a non scratching
surface.
Type 1 i (4_ (59_
, Type 2
HANDLE iNSTALLATiON
Place the handle on the door by adjusting handle
footprints to fit mounting fasteners and tighten the set
screws with a 3/32" (2,38 ram) Allen wrench .
NOTE: If the handle mounting fasteners need to be
tightened or removed use a 1/4" (6,35 ram)
Allen wrench.
ELECTRIC SHOCK HAZARD
• Disconnect electrical supply to the refrigerator
before installing. Failure to do so could result in
death or serious injury.
• Do not put hands, feet or other objects into the air
vents, base grille, or bottom of the refrigerator. You
may be injured or receive an electrical shock.
• Be careful when you work with the hinge, base grille
and stopper. You may be injured. Before removing
the doors, remove the base grille.
_CAUTION: When lifting the hinge free of the latch,
be careful that the door does not fall
forward.
Removing the left (freezer} door with water line
connection:
Pull up the water feed tube while pressing the area
(Figure 1) as shown in the figure below.
NOTE: If a tube end is deformed or abraded, trim the
part away. Disconnecting the tube under the
door causes about 0,13 gallons (0,5 liters) water
to flow out. Put a large container at end of tube
to prevent water from draining onto the floor.
1. Open the door. Remove the top hinge cover screw (1).
2.Use a flat blade screwdriver to pry back the hooks
(not shown) of the hinge cover (2) from the top of the
refrigerator cabinet (2). Lift up the cover.
3. Disconnect all the wire harnesses (3).
4. Remove the grounding screw (4).
5. Rotate hinge lever (5) counterclockwise. Lift the top
hinge (6) free of the hinge lever latch (7).
NOTE: Regardless of hinge lever type, removal process
is the same.