Table of Contents
Advertisement
3-4 FAN AND FAN MOTOR
1. Remove the freezer shelf. (If your refrigerator have an
Ice Maker, disassemble the Ice maker first)
2. Remove the grille by pulling it out and by loosening a
screw.
3. Remove the Fan Motor assembly by loosening 4 screws
and disassemble the shroud.
4. Pull out the fan and separate the Fan Motor end Bracket.
SHROUD
_\._FAN
MOTOR
FAN
Figure
12
3-5 DEFROST CONTROL ASSEMBLY
Defrost control assembly consists of Defrost Thermostat
and FUSE-M.
Defrost Thermostat
functions to defrost automatically
and it
is attached to metal side of the Evaporator
and senses
Temp,
Fuse-M is a safety device for preventing over-heating
of
the Heater when defrosting.
At the temperature
of 77°C, it stops the emission of heat
from the Heater.
1. Pull out the grille assembly.
2. Separate the connector connected
with the Defrost
Control assembly and replace the Defrost Control
assembly
after cutting the Tie Wrap. (Figure 14)
SHROUD-F
L__.
,_ Figure
13
DEF_HERMO
FUSE-M
HOLDERFUSE
Figure
14
3-6 LAMP
REFRIGERATOR ROOM LAMP
Figure
16-1
3-6-1 Refrigerator
room lamp
1. Unplug the power cord from the outlet.
2. Remove refrigerator shelves.
3. Release the hooks on both ends of the lamp shield and
pull the shield downward
to remove it.
4, Turn the lamp counterclockwise.
5. Assemble in reverse order of disassembly. Replacement
bulb must be the same specification as ofiginak
(Max 40 W)
FREEZER
ROOM LAMP
Figure
16-2
3-6-2 Freezer room lamp
1. Unplug refrigerator
or disconnect
power.
2. Reach behind light shield to remove bulb.
3. Replace bulb with a 25-watt appliance bulb.
4. Plug in refrigerator or reconnect power.
3-7 CONTROL
BOX-R
1, First, remove all shelves in the refrigerator and Control
Box-R by loosening 2 screws.
I
COVER
LAMP_@
Figure
17
2. Remove the Control Box-R by pulling it downward.
3. Disconnect
the lead wire on the right position and
seperate timer, themostat, Lamp socket, etc.
-7-
Advertisement
Table of Contents
