Table of Contents
Advertisement
Connecting
27
2. The [Connection
Setting]
menu appear on the
screen. Use A / V to select [Wireless] and press
ENTER (®).
3. Select [Yes] and press ENTER (®) to continue.
The new connection
settings
reset the current
network
settings.
4. The player scans the all available
access points
or wireless routers within
range and display
them as a list. Use A / V to select an access
point or wireless router on the list, and then
press ENTER (®).
If you have security on your access point or
wireless router, verify that the WEP or WPA key
that was entered
into the player matches
the
router's information
exactly.You
need to input
the security code as necessary.
.
@
Note
* WEP security
mode generally
have 4 keys
available on an access point or wireless
router's setting. If:your access point or
wireless router useWEP security, enter the
security
code of the key"No.1 "to connect
on your home network.
An Access Point is a device that allows you
to connect
to your home network wirelessly.
If:your access point or wireless router
supports
the PIN Code configuration
method
based on WPS(Wi-Fi Protected
Setup), press yellow
(Y) colored
button
and
note the code number
on the screen. And
then, enter the PIN number
on a setting
menu of your access point or wireless router
to connect.
Refer to the documentation
for
your network
device.
[Manual]
-Your
access point may not be
broadcasting
its access point name (SSID).
(beck
your router settings
through
your
computer
and either set your router to
broadcast S SID,
or manually
enter the access
point name (SSID) in [Manual].
[Push Button]
-If:your
access point or
wireless router that supports
the Push Button
C.onfiguration
method,
select this option
and
press the Push Button on your access point or
wireless router within
120 counts. You do not
need to know the access point name (SSID) and
security code of your access point or wireless
router.
Use A / V / < / > to select the IP mode
between
[Dynamic]
and [Static].
Normally, select [Dynamic]
to allocate an IP
address automatically.
@
Note
If there is no DHCP server on the network
and
you want to set the IP address manually,
select
[Static] then set [IP Address], [Subnet
Mask],
[Gateway]
and [DNS Server] using A / V /
</>
and numerical
buttons.
If:you make a
mistake while entering
a number, press CLEAR
to clear the highlighted
part.
6.
Select [OK] and press ENTER (®) to apply
network
settings.
7. The player will ask you to test the network
connection.
Select [OK] and press ENTER (®) to
complete
the network
connection.
8.
If:you select [Test] and press ENTER (®) at
step 7 above, the network
connection
status is
displayed
on the screen.You
can also test it on
the [Connection
Status] in the [Setup] menu.
©
o
Advertisement
Table of Contents
