KitchenAid KUCC151JSS0 Use & Care Manual page 5

Cutout dimensions
\
(7.6 cm)_
18" min.
145.7 cm)
24" rain.
(6_ _1_ 151/4" m in.
(38.7 cm)
34_h" min.
(87 cm)
1. Grounded electrical outlet must be a minimum of
3 in. (7.6 cm) away from surrounding cabinets or
nearby walls as shown. It can be placed either to
the left or the right side of the product.
Clearance dimensions
I
1. Leave 6 in. (15.2 cm) of clearance space to the
right side of the compactor in order to remove the
compactor bags.
2. Leave 23 in, (58.4 cm) of clearance in front of the
compactor in order to fully open or remove the
compactor drawer.
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Failure to follow these instructions can result in
death, fire, or electrical shock.
Recommended Grounding Method
This compactor is for use on a single phase, 115-volt, 60 Hz, AC
only 15 or 20 ampere fused and properly grounded circuit and is
equipped with a grounding plug as shown below. Time delay fuse
or circuit breaker is recommended. It is recommended that a
separate circuit serving only this appliance be provided. In the
event of an electrical short circuit, grounding reduces the risk of
electric shock by providing an escape wire for the electric
current. Do not modify the plug attached to the compactor; use
only with a grounded receptacle.
This compactor must be grounded while in use to reduce the risk
of electric shock. The compactor is equipped with a three-
conductor cord and three-prong grounding-type plug to fit the
proper grounding-type receptacle. The green (or green and
yellow) conductor in the cord is the grounding wire. Never
connect the green (or green and yellow) wire to a live terminal.
The outlet should be properly installed and grounded in
accordance with the National Electrical Code and Local codes
and ordinances. No adapter should be used with this appliance.
NOTE: Proper installation is your responsibility. Make sure you
have everything necessary for correct installation. It is the
personal responsibility and obligation of the customer to contact
a qualified installer to assure that electrical installation meets all
National and Local codes and ordinances.
Tools and materials needed for installation:
Level Phillips No. 2 Screwdriver
Tape Measure Flat-Head Screwdriver
Pliers 5/16 in. Hex-Head Socket Wrench
Scissors Utility Knife