Setting A Delay Start; Drying System - KitchenAid Sculptura KUDI24SE Use & Care Manual

Setting a delay start
To run your dishwasher at a later time or
during off-peak hours, you can delay the
start of a cycle for 2, 4, or 6 hours, depend-
ing on your model. To delay the start, follow
these steps:
Example for delayed Normal cycle with
Energy Saver Dry
1. Press a Wash Selection pad for the
desired cycle. See chart on page 15 for
cycle descriptions.
2. Press a pad to select an option. If you
change your mind, press the pad again
to turn the option off. To select a different
option, press another pad. See page 16
for option selections.
3. Press the Delay Hours pad.
On models with a 4-hour delay start:
Press the Delay Hours pad once, then press
the Start pad.
On models with 2-, 4-, and 6-hour
delay start:
Press the Delay Hours pad once for a
2-hour delay start, twice for 4 hours, or
three times for 6 hours, then press the
Start pad.
The number above the Delay Hours
pad will glow and the dishwasher will start
the cycle in the amount of hours you have
selected.
4. To turn Delay Hours off, press the pad until
no number is lit above the pad.
IMPORTANT:
• Operate your dishwasher only when you are
at home.
• If your home is equipped with a water soft-
ener, make sure the dishwasher is not timed
to start during regeneration of the softener.
Drying system
During drying, vapor escapes through the
vent at the upper left corner of the door.
This is normal. The vapor is the result of
moisture in the dishwasher being removed
during drying.
IMPORTANT: The vapor is hot. Do not touch
the vent during drying.
I t • •
# I • •
• _ ii11