Adding Dishes During A Cycle; Setting A Delay Start - KitchenAid Sculptura KUDS24SE Use & Care Manual

Adding dishes during a cycle
You can add an item to the dishwasher
during the first 10 minutes of the cycle.
1. Unlatch the door to stop the cycle. Wait a
few seconds for the spray action to stop
before opening the door.
2. Open the door and add the dishes.
3+Close the door.
4. The dishwasher will start automatically
after a 5-second pause when you close
the door.
Setting a delay start
To run your dishwasher at a later time, or
during off-peak hours, you can delay the
start of a cycle for 2, 4, or 6 hours.
To delay the start, follow these steps:
Example for delayed Normal cycle with
Energy Saver Dry
+
Press a Wash Selection pad for the
desired cycle. See chart on page 18 for
cycle descriptions.
Press a pad to select an option. If you
change your mind, press the pad again to
turn the option off. To select a different
option, just press another pad. See page
19 for option selections.
.
Press the Delay Hours pad once for a
2-hour delay start, twice for 4 hours,
or three times for 6 hours, then press
the Start pad.
The number above the Delay Hours
pad will glow and the dishwasher will start
the cycle in the amount of hours you have
selected.
4. To turn Delay Hours off, press the pad
until no number is lit above the pad.
IMPORTANT:
* Operate your dishwasher only when you are
at home.
o If your home is equipped with a water soft-
ener, make sure the dishwasher is not timed
to start during regeneration of the softener.
Drying system
During drying, vapor escapes through the
vent at the upper left corner of the door.
This is normal. The vapor is the result of
moisture in the dishwasher being removed
during drying.
IMPORTANT: The vapor is hot. Do not touch
the vent during drying.