Optional Front Panels - KitchenAid KUDI220W Use And Care Manual

Lower Panel:
H
8. Lift support tabs (E)of panel assembly up
and push lower portion of panel back
until support tabs (E) rest on kick plate
(F).
9. Replace the screws (D).
10. Check that upper and lower panels are
secure.
11. Reconnect electrical power supply
I
E
F
Optional Front
Panels
I. Remove two screws (D) located under
panel assembly
2. With hands placed under ends of panel,
lift support tabs (E) and pull out until tabs
clear kick plate (F).
3. Pull lower panel down until side flanges
(G) clear the support strip (H). Lower panel
is then removed from dishwasher.
4. Place panel on a smooth, flat surface and
remove the two screws (I) from either side
of the trim. Take off the loosened piece of
trim.
5. Slide the color panel out. Handle carefully
so the panel will not be scratched or bent.
Turn the panel to the desired color. Place
the color panel in position then push the
filler panel in place.
6. Replace the trim and screws (I).
7. Taking the assembled lower panel, slide
the panel up onto the dishwasher front so
that the side flanges (G), fit up behind the
support strip (H). If this is done improperly,
the lower panel will be loose and may fall
off the dishwasher.
1, Wood and Decorative Panels
The stainless front trim will accommodate
a custom wood front or a decorative panel
insert, 1/4inch thick. Some wood panels and
decorative panels are heavy and require
heavy dishwasher door springs. These may
be ordered from your KitchenAid dealer as a
service item, part #4171002. For more
information on installing a custom wood
front, refer to the Dishwasher Installation
instructions. If you have misplaced these
instructions, please write to:
Customer Relations Department
KitchenAid, Inc.
P.O. Box 558
St. Joseph, M149085-0558
2, Solid Colors
If the four colors provided with your
dishwasher do not match your kitchen decor,
optional panels are available from your
KitchenAid dealer in a variety of decorator
colors.
22