Advertisement
Available languages
Available languages
When to use the Remote
UP/DOWN
ControJ
The Remote UP/DOWN Control should be used when your
cooktop has a burner that is within 4 inches of the UP/DOWN
Button on the downdraft chimney.
The Remote UP/DOWN Control can be used for convenient
UP/DOWN operation of the downdraft chimney (even when a
burner is more than 4 inches from the UP/DOWN Button of the
downdraft chimney).
How to use the Remote
UP/DOWN
Contro!
Do net place the remote control where it wiII interfere with
cooking, where hot pans couId be set, or where hot liquids
could be spilled on the control.
The Remote UP/DOWN Control disables the UP/DOWN func-
tion of the UP/DOWN Button on the downdraft chimney.
installation
1. Using the template at right, lay out the 3-hole pattern on the
counter top. Mark the centers of the three holes to be drilled.
2. Carefully drill the three holes through the counter top. Be
careful not to damage or chip the counter top surface when
drilling the holes.
3. Remove the control from the plastic bag. Line the control up
with the three holes and position the control so it is parallel
with the front of the counter top.
4. Remove the two nylon thumbnuts from the plastic bag and
thread onto the two studs on the control from below the
counter top. Hand tighten only.
WARNING: To reduce the risk of burns or ignition
of clothing
by reaching
across
burners,
the re-
mote control
must be mounted
at least 4" away
from any cook top burner.
5. Remove the blower, clamp channels, and gearmotor cover
from downdraft (see"Prepare the Downdraft" on page 5)=
Remove the large panel to expose the downdraft's wiring.
6. At the lower right hand corner of downdraft,
unplug the
cabIe from the left side of the wiring box.
7= Remove remote cable from the plastic bag and plug into back of
control from below counter top. Route cable through cabinet to
lower right hand corner of downdraft and through the clearance
holes in the side of downdraft and wiring box. Plug cable into
circuit board plug, as shown=
8. Stuff excess cable out of the way, secure the cable so it is not
damaged by items stored in the cabinet, and reassemble
downdraft.
2.000
1
.250 DmA.
HOLES
.438
DIA.
WIRING
BOX
WIRING
BOX
--f-
.750
DOTTED
UNE
LOWER
RIGHT
SIDE
OF
DOWNDRAFT
CABINET
FLOOR
REMOTE
CABLE
Advertisement
