Advertisement
Connecting
A Liquid Propane Gas (LP gas)
Figure 7a (LP gas model only)
Tank To Your Grill
1. Remove the Pull-out Grease Draining Tray with the
Heat Shield from Grill.
2. Locate hose and regulator assembly packed for
shipping purposes on front underside of grill head.
Remove fastening band. Push assembiyto
back of
grill and pull down to connect to tank valve. Before
connecting, check valve and assembly threads to
be sure they match. (Type 1 connection per ANSI
Z21.58a-1998). See Fig 7b
3. Inspect the valve connection port of the regulator
assembly. Look for damage or debris. Remove any
debds. Inspect hose for damage. Never use dam-
aged or plugged equipment.
4. Pull out the LPG Tank Pull-out Tray. Place a
20 lb tank with foot ring into the hole in the
tray. See Fig.7a.
Make sure the tank valve is
in the OFF positon.
5. Align the tank so the Tank Valve faces the rear
right comer of cabinet.
Usethe 5!16"x89mm Wing
Bolt to secure gas tank from rear of tray.
See Fig. 7a.
6. Check the tank valve to ensure it has proper
external
mating threads to fit the hose &
regulator assembly provided
(Type 1 connec-
tion per ANSI Z21.58a-1998).
See Fig.7b
7. Make sure ait Burner knobs are in the OFF
position.
8. Connect the hose and regulator assembly to the
tank valve (See Fig 7b) Hand tighten Quick Coupling
Nut clockwise to a full stop. DO NOT use a wrench
to tighten because it could damage the Quick
Coupling Nut and result in a hazardous condition.
9. Open the tank valve fully (counterclockwise).
Use a
soapy water solution to check ait connections for
leaks before attempting to light your gdll. See
"Checking for LP Gas Leaks" on page 15. Ifa leak
is found, turn the tank valve off and do not use your
grill until the leak is repaired.
FRONT
DOOR
GAS
LJ
TANK
TANK PULL-OUT
TRAY
Figure 7b (LP gas model only)
5/16"x89mm
WING
BOLT
GRILL HEAD
Disconnecting
A Liquid Propane Gas (LP gas)
Tank From Your Grill
1. Turn the Burner Knobs and LP gas tank valve
to the full OFF position. (Turn clockwise to
close.)
2. Detach the hose and regulator assembly from
the LP gas tank valve by turning the Quick
Coupling
Nut counterclockwise.
See Fig.7b
CAUTION: When the appliance
is not in use, the
gas must be turned off at the supply tank.
14
FRONTDOOR
T_e
I
per ANSI Z21.58a-1998
TANK P
TRAY
QUICK
COUPLING
NUT
ALREADY
CONNECTED
TO ADAPTOR
UNDER
SIDE BURNER.
Advertisement
