Adjusting Controls Settings; Water Dispenser - Kenmore ELITE 795.7834 Series Use & Care Manual

• Dispenser Light:
When the Light button is pressed, the display will
indicate the selected function.
Press the LIGHT button once to turn On/Off the
dispenser Lamp.
When water dispenser Pad is used also the dispenser
light will be illuminated.
• Display Off Mode:
Initially the display Off mode is enable.
After 20 seconds of control panel inactivity the
display is turned off.
It display Off mode press and hold ULTRA ICE and
FREEZER buttons over 5 seconds until the lights tilt.
To activate this mode again execute previous method.
Display Off mode does not affect the temperature
control setting of the unit.
ADJUSTING CONTROL SETTINGS
Give the refrigerator time to cool down completely before
adding food. It is best to wait 24 hours before you put
food into the refrigerator. The mid-settings indicated in the
previous section should be correct for normal household
refrigerator usage. The controls are set correctly when
milk or juice is as cold as you like and when ice cream
is firm.
Always remember to wait at least 24 hours between
adjustments.
CONDITION/REASON:
REFRIGERATOR section
too warm
• Door opened often
Large amount of food added
• Room temperature very warm
RECOMMENDED
ADJUSTMENT:
Turn
REFRIGERATOR
control to next
higher number,
wait 24 hours,
then re-check
FREEZER section too warm/
ice not made fast enough
• Door opened often
• Large amount of food added
• Very cold room temperature
(can't cycle often enough)
• Heavy ice usage
• Air vents blocked by items
REFRIGERATOR section too
cold
" Controls not set correctly for
your conditions
Turn FREEZER
control to next
higher number,
wait 24 hours,
Then re-check
Move items out of
airstream
Turn
REFRIGERATOR
control to next
lower number,
wait 24 hours,
then re-check
FREEZER section too cold
• Controls not set correctly for
your conditions
Turn FREEZER
control to next
lower number,
wait 24 hours,
then re-check
The refrigerator control functions as the thermostat for the
entire appliance (refrigerator and freezer sections.) The
higher the number setting, the longer the compressor will
run to keep the temperature colder. The freezer control
adjusts the cold air flow from the freezer to the
refrigerator. Setting the freezer control to a lower
temperature keeps more cold air in the Freezer
compartment to make it colder.
If you need to adjust temperatures in the refrigerator or
freezer, start by adjusting the refrigerator first. Wait 24
hours after the refrigerator adjustment to check the
freezer temperature. If it is too warm or too cold, then
adjust the freezer control as well.
Use the settings listed in the chart below as a guide.
WATER DISPENSER
Push the dispenser pad with
a glass until you hear a click
to get cold water.
Tray can be easily removed
by pressing and pulling it.
Dispenser
SWitp_sh
I
Tilt up the front of tray slightly
and snap the ribs into the holes
to replace the tray.
IMPORTANT: When the refrigerator is first connected to
the water supply, it is necessary to dispense 2.5 gallons
(9.46L) of water to purge the system, depressing and
releasing the dispenser button (30 seconds ON,
60 seconds OFF). Open the refrigerator door and shelf
area to check for water leaks.
17